We often talk about preventive measures, then the particle machine failure how early prevention?

First, the particle unit should be used in a dry room, can not contain in the atmosphere of corrosive gases such as acids used in the use of places.

Second, the regular inspection of mechanical parts, to see whether the work is normal, a monthly inspection, inspection, including the worm, worm, lubrication block on the bolt, bearing and other activities are flexible and wear parts of the situation, found that defects should be promptly repaired, not And then continue to use.

Third, the use of particles after the completion of the unit or stop, you should remove the rotating drum to clean and brush the bucket inside the remaining powder (only for some particle units), and then installed for the next use to prepare.

Fourth, when the drum in the work before and after the occurrence of movement, should be adjusted before the bearing stroke M10 screw to the appropriate location. If the gear shaft is moving, adjust the M10 screw to the proper position on the rear of the bearing frame, adjust the clearance to make the bearing no sound, and turn the pulley, the proper fit is appropriate. If too tight or too loose, the unit may be damaged.

5, if the deactivation time is too long, the particles must be wiped clean the body unit, and the smooth parts of the machine coated with anti-rust oil, with a good cloth.

As long as the above work, you can greatly reduce the particle machine failure, so that the efficiency of the pellet machine to achieve the highest level.