As the wood particles ignited together, there were wood pellet machines, from the first flat-mold sawdust particle machine to the later horizontal ring-shaped sawdust particle machine, to the now popular vertical ring mold wood pellet machine, structure. Constantly updated.

        However, no matter how the granule machine model changes, the mold as a wearing part is always replaced.

        Granulator molds are a major cost in the production of wood pellets. Proper maintenance directly affects the service life of the wood pellet machine mold, and therefore directly affects the processing cost of the wood pellet.

        So what are the ways to make the mold of the wood pellet machine last longer? The AOLS pellet machine teaches you 5 small tricks to make the mold life of the wood pellet machine longer.

1. Regularly clean the granule oil

        Friends who have processed wood pellets know that after the end of production, oil is used instead of sawdust to remain in the mold hole. I would like to remind everyone that if the mold is not used for more than one month, it is recommended to take out the oil in the mold, because the oil will gradually harden during long-term storage, which will make it difficult to remove the next time, which will seriously affect the service life of the mold. .

2, the mold should be stored in a dry and ventilated place

        The molds of the wood pellet machine are mostly made of alloy steel. If it is in a humid place for a long time, the surface of the mold may be damaged due to the corrosion of the air, thereby greatly reducing the service life.

3. Fill with oil

        The oil can be mixed with waste engine oil and wood. It can be recycled at one time.

        After the daily processing of the granules, the oil should be ground for a period of time to ensure that all the oil remains in the mold holes, which is of great benefit to the work of the next day and is also beneficial to the long-term use of the mold.

4, the handling process should be careful

        The mold of the wood pellet machine belongs to high-precision fittings. The die holes are carefully processed according to the compression ratio of the die. If the carelessness during the handling process damages the structure of the inner wall of the die hole, it may cause the sawdust particles to be processed. The molding rate is low and the wood pellet machine has a short service life.

5, need to clean the mold when not in use for a long time

        If the mold and the pressure roller are not used for a long time, it is recommended to remove the mold and clean it for storage.

        It mainly cleans the particles inside the mold and the sawdust attached to the surface of the mold.

        On the one hand, it is difficult to remove the particles due to long-term storage, and on the other hand, due to the water absorption of the sawdust, if the sawdust on the surface is not removed, the surface of the mold may be accelerated.

        The above five methods are the tips for making the wood pellet machine die longer. According to these five methods to maintain the mold, I believe that your mold will last longer and the efficiency will not be much lower.